Autolink Installation - 3Com 10/100BASE-T4 User Manual

3-6 C 3: L
HAPTER

AutoLink Installation

To use the AutoLink program to install NetWare DOS ODI client
software on a PC with a single adapter, follow these steps:
1 Make sure that you have booted the computer under DOS,
version 3.1 or later, and that your computer is connected
to the network, as detailed in Chapter 2.
2 Insert the EtherDisk diskette in a floppy drive on your
computer and make that drive the active drive.
For example, if the floppy drive is A, type the following
command:
A: [Enter]
3 At the prompt, type:
INSTALL [Enter]
Alternatively, at the prompt, type:
AUTOLINK [Enter]
If you type AUTOLINK instead of INSTALL, you will bypass the
EtherDisk diskette menu program (skipping steps 5 and 6)
and advance to step 7.
4 The first time you use the diskette to install an adapter, a
license screen appears. To accept the terms and conditions
of the 3Com end-user software license agreement, type
the following:
Y
To view the full text of the license agreement, press [F1].
Once you have agreed to the terms and conditions of the
3Com license agreement, the license screen will not appear
again.
The Auto Installation Information screen appears, as shown in
Figure 3-1.
N
OADING THE ETWORK
D
RIVERS