Table of Contents
Advertisement
ACCELLIS C70
TEST FUNCTION QUICK REFERENCE
Press the BACK
key
until the display
reads
OVEN OFF.
Press the
BACK & ENTER
keys at the same
time for 3 seconds
Display reads
ENTER ACCESS
CODE
Select XXX code
press ENTER
FIGURE 1
The test function allows the technician to operate
components individually and get diagnostic
information. There are 2 pages of test functions.
To change pages use the DOWN ARROW key.
Refer to the brief descriptions on this page to help
determine which test function will help you. Before
operating a test function, read the full description
of the test function on these following pages.
and
DISPLAY PAGE 1
CCXX --- thermocouple cooking cavity temperature
BLOWER – runs the blower motor in 10% increments
ELEC – thermocouple electrical compartment tem-
perature
STEST – initiates the self test function
HXXX – thermocouple heat exchanger temperature
HEATER -- turns on HOT AIR heater element
MGTRON – (press & hold) runs the magnetron circuit
DIAG – runs the cooking display w/status indica-
tors at the bottom of the display
DISPLAY PAGE 2
CCXX --- thermocouple cooking cavity temperature
HXXX – thermocouple heat exchanger temperature
S/N – for entering the serial number of the C70
CCC --- number of cook cycles
PIN – enters a new 3 digit password number
F/C -- Fahrenheit or Celsius temperature display
FF – view and reset cook fault counters
IAF – allows you to view or change the Idle Airflow
3---1
Advertisement
Table of Contents
