Panduit TDP43H Operator's Manual page 44

Section 3: Configuration
CARD->MEMORY
COPY COPYING
CARD->MEMORYCOPY
COMPLETED
CARD COPY/FORMAT
XXXXXXX ERROR
MEMORY->CARDCOPY
ALL <0MB>
COPY START
YES NO
MEMORY->CARDCOPY
COPYING
MEMORY->CARDCOPY
COMPLETED
CARD COPY/FORMAT
XXXXXXX ERROR
CARD->MEMORYCOPY
PROGRAM
COPY START
YES NO
Page 3-18
3. Press the FEED key to accept the selection. If Yes was selected
the copy process will start.
4. Once the copy process is completed, press the FEED key to
step the display.
5. If an error is encountered in the copy process, one of the
following messages will be displayed on the second line:
R/W Error
No Card Error Indicates no card was recognized
Mem Full Error Indicates that there is insufficient memory
available.
This selection allows you to copy the entire contents of the optional
Expanded Memory to the PCMCIA Memory card installed in the
Y/N
Memory Card slot on the rear of the printer.
1. Use the LINE key to step the cursor to desired setting. If Yes is
selected, the printer will enter the Card Copy mode. If No is
selected, the display will advance to the Card to Memory Copy
All mode.
2. Confirm your selection by stepping the cursor to the Yes
selection. If you select No, the display will return to the previous
selection.
3. Press the FEED key to accept the selection. If Yes was selected
the copy process will start
4. Once the copy process is completed, press the FEED key to
step the display.
5. If an error is encountered in the copy process, one of the
following messages will be displayed on the second line:
R/W Error
No Card Error Indicates no card was recognized
Mem Full Error Indicates that there is insufficient memory
available.
This selection allows the user to copy printer firmware from the
Y/N PCMCIA Memory Card to the printer.
1. Use the LINE key to step the cursor to desired setting. If Yes is
selected, the printer will enter the Card Copy mode. If No is
selected, the display will advance to the mode display.
2. Confirm your selection by stepping the cursor to the Yes
selection. If you select No, the display will return to the previous
selection.
GMTDPH-MAN
Indicates a Read/Write error occurred
Indicates a Read/Write error occurred
PANDUIT TDP4*H