5.- INSTALLATION OF ACCESSORIES:
5.1.- INSTALLING THE ANTENNA:
Install the antenna as shown in the figure belowand turn it clockwise
until it stops.
Note:
- When installing the antenna, don't rotate it by its top.holding it
by its base and turn.
- If you use an external antenna, make sure the 'SWR' is about 1.5:1
or less, to avoid damage to the transceiver's final transistors.
- Do not holdthe antenna with your hand or wrap the outsideof it
to avoid bad operation of the transceiver.
- Never transmit without an antenna.
5.2.- INSTALLING THE BELT CLIP:
If necessary, install thebelt clipat the rear ofthebatten compartment
cover as shown in the figure below.
Note:
- Donot use any kind ofglue to fix thescrew onthebelt clip. The
solvents Glue maydamage the battery casing.
5.3.- MICRO-HEADSET INSTALLATION OF EXTERNAL:
Plug the external micro-headset connector intothejackof 'SP. & MIC
of the transceiveras shown in the figure below.
05