Installing The Belt Clip; Installing The Cap Over The Speaker/ Microphone Jacks - Kenwood ProTalk tk-3501 Quick Reference Manual

INSTALLING THE BELT CLIP

1 Remove the battery pack. {p. 2}
2 To install the belt clip, align the guides
of the belt clip with the grooves on the
rear of the battery pack, then slide the
belt clip into place until the lock lever
is secure.
3 To remove the belt clip, push the
lock lever towards the transceiver
while sliding the belt clip up.
INSTALLING THE CAP OVER THE SPEAKER/
MICROPHONE JACKS
If you are not using a speaker/ microphone
or Headset, install the cap over the
speaker/ microphone jacks using the
supplied M3 x 6 mm screws.
Note:
To keep the transceiver water resistant, you
◆
must cover the speaker/ microphone jacks
with the supplied cap.
Belt clip
Lock lever
Cap
3