Electrical Instructions - Southern Pride MLR-150 Owner's Manual

Electrical Requirements:

230 volts AC, 50 Hz, 16 A IP23

2 wire with ground
THE WARRANTY IS VOID IF THE SMOKER IS CONNECTED TO ANY VOLTAGE OTHER
THAN SPECIFIED ABOVE AND ON THE SMOKER DATA PLATE.
Remove all packing material before connecting the electrical and gas supply to the smoker.

An electrician must provide the conduit and wire for electrical hookup.

The power is to be left OFF throughout the installation.

The electrical service is connected via the factory supplied power cord normally located to the rear of the
smoker on the service bay side. Alternatively, the power cord can be removed and the smoker hard wired.

On models equipped with an optional smoke extractor, the electrician must provide conduit and wire
hookup from the junction box, located on the rear of the smoker, to the exhaust fan. Make the electrical
connections inside the junction box.
NOTE: 230 V.A.C., 1/4 hp maximum connected load, 1100 CFM (31 m
recommended for smokers equipped with the optional smoke extractor damper.
5. If venting or gas connections are to be done at a later time, be sure that the power remains OFF.
Smoker extractor damper (Optional)
Rear View of
Smoker
INSTALLATION INSTRUCTIONS

ELECTRICAL INSTRUCTIONS

Junction box
(Auxiliary power connection
for smoke extractor exhaust fan)
DO NOT connect incoming power.
Power connection
Gas supply
connection
Shown configured with
right-hand firebox. Con-
nections points are mir-
rored if configured with
left-hand firebox.
12 of 38
WARNING:
This appliance, when installed, must be electrically
grounded in accordance with local codes.
Smoke extractor
damper
(Optional)
Rear flue
(Optional)
WARNING:
The junction box
is not a power
supply connection.
Copyright 2016 by Southern Pride Distributing, LLC Volume 2
3
/m) fan rating
Junction box
(Auxiliary power connection)