Gigaset C610A Manual page 52

Using a handset as a room monitor (Babyphone)
When the room monitor is activated, incom-
ing calls to the handset are indicated with-
out a ringtone and only display on the
screen. The display and keypad are not illu-
minated and advisory tones are also turned
off.
If you accept an incoming call, the room
monitor is suspended for the duration of the
call, but the function remains activate.
If you deactivate, then reactivate the hand-
set, the room monitor remains activated.
Warning!
u
Always check the operation of the
room monitor before using it. For
example, test its noise sensitivity.
Check the connection if you are
diverting the room monitor to an
external number.
u
When the function is switched on, the
handset's operating time is considera-
bly reduced. If necessary, place the
handset in the base/charging cradle.
This ensures that the battery does not
run down.
u
Ideally the handset should be posi-
tioned 1 to 2 metres away from the
baby. The microphone must be
directed towards the baby.
u
The connection to which the room
monitor is diverted must not be
blocked by an activated answering
machine.
50
Activating the room monitor and
entering the destination number
É
¢ ¢
v
Room Monitor
¤
Change multiple line input:
Activation:
Select On to activate.
Alarm to:
Select Internal or External.
External number: Select the number
from the directory (press the display key
ö
) or enter it directly.
Internal number: Select the display key
¢
§Change§
Select the handset or Call All
to call all registered handsets
Two Way Talk:
Switch the handset's speaker on or off
(select On oder Off).
Sensitivity:
Select sensitivity for noise level (Low or
High).
¤
§Save§
Press to save the settings.
In idle state, the destination number or
the internal destination number displays.
When the room monitor function is acti-
vated, the idle display appears as shown
below:
i à V
07:15 am
Á
INT 1 Oct 22
Room Monitor
9725551234
Off Options
¢
§OK§
.