Using The Cli To Configure Ldap - Cisco 2100 Series Configuration Manual

Configuring LDAP
Figure 5-20
d.
e.
f.

Using the CLI to Configure LDAP

Use the commands in this section to configure LDAP using the controller CLI.
Refer to the
Note
values of the parameters used in the CLI commands.
1.
Cisco Wireless LAN Controller Configuration Guide
5-36
WLANs > Edit (Security > AAA Servers) Page
From the LDAP Servers drop-down boxes, choose the LDAP server(s) that you want to use with this
WLAN. You can choose up to three LDAP servers, which are tried in priority order.
These LDAP servers apply only to WLANs with web authentication enabled. They are not
Note
used by local EAP.
Click Apply to commit your changes.
Click Save Configuration to save your changes.
"Using the GUI to Configure LDAP" section on page 5-33
Use these commands to configure an LDAP server:
config ldap add index server_ip_address port# user_base user_attr user_type—
•
Adds an LDAP server.
config ldap delete index—Deletes a previously added LDAP server.
•
config ldap {enable | disable} index—Enables or disables an LDAP server.
•
Chapter 5 Configuring Security Solutions
for the valid ranges and default
OL-17037-01