Installing The Camera Assembly; Figure 1-8 Power Cable Connection - Honeywell JOSI-DBC012-N11 Installation Manual

Installing the Camera Assembly

Document 800-01605 Rev A
04/08
Note For secure installations, surface-mounted cables should be protected by
plastic or metal cable covers.
Figure 1-8 Power Cable Connection
To install the camera assembly into the ACUIX™base:
1. Loosen all three thumb nuts on the camera chassis (see
2. Slide the gimbal ring under the two tabs on either side of the thumb nuts on each
bracket (total of 6 tabs).
3. Adjust the camera position. See "Adjusting the Camera" on page 25.
4. Tighten all three thumb nuts to secure the camera assembly.
Make sure that the camera DIP switches are on the top of the lens mount when the
ACUIX™is mounted on the wall or ceiling.
TM
ACUIX Fixed Dome User Guide
Gimbal assembly
Power/video
Power supply board
Figure 1-9).
21