DSC PC585 Installation Manual page 33

P R O G
[005] System Times
Default [001-255]
030
I _ ______I _ ______I _ ______I
045
I _ ______I _ ______I _ ______I
120
I _ ______I _ ______I _ ______I
040
I _ ______I _ ______I _ ______I
[006] Installer's Code
(Section 4.1 "Installer Programming")
Default
0580
I _ ______ I _ ______I _ ______I _ ______I
[007] Master Code
(Section 5.1 "Programming Security Codes")
Default
1234
I _ ______ I _ ______I _ ______I _ ______I
[008] Maintenance Code
(Section 5.1 "Programming Security Codes")
Default
AAAA
I _ ______ I _ ______I _ ______I _ ______I
[009] PGM Output Programming (PGM 1 and 2)
(Section 5.11 "PGM Output Options")
Programmable Output Options
01 Burglary and Fire Bell Output
02 For Future Use
03 Sensor Reset
04 For Future Use
05 System Armed Status
06 Ready To Arm
07 Keypad Buzzer Follow Mode
08 Courtesy Pulse
09 System Trouble Output (with Trouble options)
10 System Event [Strobe (with Event options)]
11 System Tamper (all sources: zones, kpd, modules)
12 TLM and Alarm
Output types [03] and [20] cannot be used together on the same system.
Default
19
I _ _ _____I _ _ _____I
10
I _ _ _____I _ _ _____I
Program PGM Option Attributes in sections [141] & [142].
[012] Keypad Lockout Options
(Section 5.21 "Keypad Lockout Options")
If Keypad Lockout is active, the panel cannot be disarmed with a keyswitch.
Default
000
I _ ______I _ ______I _ ______I
000
I _ ______I _ ______I _ ______I
[013] First System Option Code
Default Option
OFF
I _ _ ______I
OFF
I _ _ ____ __I
ON
I _ _ ______I
OFF
I _ _ ______I
OFF
I _ _ ____ __I
ON
I _ _ ______I
ON
I _ _ ______I
OFF
I _ _ ____ __I
* Option 3 must be OFF if LCD keypads older than v2.0 are used.
R A M M I
Entry Delay 1 (in seconds)
Entry Delay 2 (in seconds)
Exit Delay (in seconds)
Bell Cut-off (in minutes)
PGM 1
PGM 2
Number of Invalid Codes Before Lockout (001-255 codes)
Lockout Duration (001-255 minutes)
ON
1 Normally Closed Loops
2 Double End-of-Line Resistors
3* Panel shows all troubles when armed
4 Tampers/Faults do not show as open
5 For Future Use
6 Audible Exit Fault Enabled
7 Event Buffer Follows Swinger Shutdown
8 Temporal Three Fire Signal Enabled
N G W O
(Section 5.18 "Entry/Exit Delay Options")
(Section 5.18 "Entry/Exit Delay Options")
(Section 5.18 "Entry/Exit Delay Options")
(Section 5.13 "Siren")
13 Kissoff Output
14 Ground Start Pulse
15 Remote Operation (DLS-1 Support)
16 LINKS1000 Support (PGM1 only)
17 Away Armed Status
18 Stay Armed Status
19 Command Output #1 ([ ] [7] [1])
20 Command Output #2 ([ ] [7] [2])
21-24 For Future Use
OFF
End-of-Line Resistors
Single End-of-Line Resistors
Panel shows only Fire troubles when armed 3.4
Tampers/Faults show as open
Audible Exit Fault Disabled
Event Buffer Logs Events Past shutdown
Standard Pulsed Fire Signal
29
R K S H E E T S
Section
2.8
2.8
3.4
5.18
5.20
5.13