Panasonic AJ-HD2000 Operating Instructions Manual page 87

TC/CHR CONVERT menu
Key Key designation
F12 HD SUPER
F13 LTC OUT°
°This item appears only when the 1080/23p, 1080/24p, 1080/50p or 1080/50i system format is used. When 30TC is
selected as the setting, the continuity of the time code is guaranteed only in the 1t tape travel servo lock status.
Bear in mind that the time code will be discontinuous at all other times.
When the audio insert editing status has been established by selecting ON as the setting for the F6
(RC_30SYS) key and 30TC for the F10 (RC_TC) key,
menu and MANUAL EDIT menu, as shown below.
∑ Concerning the TC SYNC value and sync phase settings
Since the TC is similarly converted when the 1080/23psf (p) or 1080/24psf (p) format is converted into the
1080/59i (480/59i) or 1080/60i format, it is necessary to input the time information (TC SYNC value) that will
serve as the reference for conversion and the 3:2 pull-down sequence (sync phase) of the post-conversion
output images.
∑ Setting the TC SYNC value
Input the pre-conversion TC with the frame count of 24 (24TC) and the post-conversion TC with the frame
count of 30 (30TC)/25 (25TC) to serve as the reference for conversion.
ONoteN
When converting from 1080/25psf to 1080/23psf to 1080/59i (480/59i), or from 1080/25psf to 1080/24psf
to 1080/60i
Input the pre-conversion 25-frame count TC (25TC) value that will serve as the reference during conversion
and the post-conversion 24/30-frame count TC (24TC)/(30TC) value. SYNC PHASE is valid during the 24TC
to 30TC conversion.
For selecting the time code which is to be output to the HD
monitor connector.
24TC: The original time code with the frame count of 24 is
output.
30TC: The post-conversion time code with the frame count of
30 is output.
(25TC): The post-conversion time code with the frame count of
25 is output.
For selecting the time code which is to be output to the LTC
output connector. (For details, refer to page 90.)
(25TC): This item appears only when the 25/50 Hz has been
selected as the system frequency.
30TC: The post-conversion time code with the frame count of
30 is output.
24TC: The time code with the frame count of 24 is output.
RC 30SYS
OUTPUT FREEZE EJT CTL TC/CTL
EE OFF RESET TC
F1 F2 F3 F4
– 87 –
Description
will appear at the top right of the HOME
RC 30SYS
REC INH
FREE
8
TC/UB TC CLR TC HOLD
TC RESET HOLD SETUP
F5 F6 F7 F8
F13
F12
F11
F10
F9