Panasonic AJ-D650 Operating Instructions Manual page 9

Headphones jack
The sound being recorded, played back or edited can be monitored on stereo
headphones when they are connected to this jack.
Volume control
This is used to adjust the headphones volume.
Audio recording level controls
These are used to adjust the recording levels of the analog audio signal CH1/CH2.
CTL/TC/UB switch
Use this switch when selecting the counter display.
CTL: Tape timer (control signal) is displayed.
TC: Time code is displayed.
UB: User bit is displayed.
MONITOR SELECT switch
This is used to select the audio signals output to the monitor channel.
(With the No. 713 (MONI CH SEL) setting on the setup menu, the display may not match
the monitor output.)
INT/EXT switch
INT:
For using the built-in time code generator.
For using the time external code which is input from the time code input connector
EXT:
or the video signal VITC. The selection is set at the setup menu.
MENU button
When this is pressed, the setup menu appears on the TV monitor using VIDEO OUT 3
connector, and the setup menu No. appears on the display.
When it is pressed again, the setup mode is exited and the original operating mode is
restored.
TC PRESET (FILE) button
When this is pressed, the time code setting mode is established.
User file can be selected when the cursor buttons
menu mode. (For details, see setup menu items on page 26.)
Cursor buttons
These are used when setting time codes and settings at menu setup.
These change the flashing digit in the time code indicators.
Each time they are pressed, the flashing indicator moves incremently to the left or
right.
increments to the left;
: These change the flashing digit in the time code indicators.
Each time they are pressed, the indicated value increments and decrements.
decrements the value;
The flashing digit changes continuously when the button is continuously pressed.
For details about operation during setup menu mode, see setup menu items (page 25).
increments to the right.
increments the value.
– 9 –
are used during the setup