Verifying The Controlling Port Authorization State - Cisco 1941W Configuration Manual

Controlling Port Authorization State
DETAILED STEPS
Command or Action
Step 1 enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3 interface gigabitethernet slot/port
Example:
Router(config)# interface gigabitethernet
0/0
Step 4
authentication port-control {auto |
force-authorized | force-unauthorized}
Example:
Router(config-if)# authentication
port-control {auto | force-authorized |
force-unauthorized}
Step 5
mab
Example:
Router(config-if)# mab
Step 6 end
Example:
Router(config-if)# end
Router#

Verifying the Controlling Port Authorization State

Use the show authentication sessions and show dot1x commands to verify the Controlling Port
Authorization state:
c1921#show authentication sessions
Interface
Gi0/1
c1921#show authentication sessions interface gi0/1
Cisco 3900 Series, Cisco 2900 Series, and Cisco 1900 Series Integrated Services Routers Generation 2 Software Configuration Guide
160
MAC Address Method
(unknown) dot1x
Interface: GigabitEthernet0/1
MAC Address: Unknown
IP Address: Unknown
Chapter Configuring Identity Features on Layer 3 Interface
Purpose
Enables privileged EXEC mode. Enter your
password if prompted.
Enters global configuration mode.
Enters interface configuration mode.
Enables the manual control of the port
authorization state.
auto-Allows only EAPol traffic until successful
authentication.
force-authorized-Allows all traffic, requires no
authentication.
force-unauthorized-Allows no traffic.
Enables MAC-based authentication on a port.
Returns to privileged EXEC mode.
Domain Status
DATA Authz Success
Session ID
030303030000000A002CFCBC