Manual Clock Setting; Tv Operation - Panasonic PV C923 Operating Instructions Manual

MANUAL CLOCK SETTING

You must set the date and time manually for Timer
Recordings, ON/OFF Timer and Daylight Saving Time
if the Auto Clock process did not set them correctly.
EXAMPLE: Setting the clock to "8:30 AM", 29th (WED)
October, 2003.
1
Press the MENU button.
Press the SET/TRACKING + or –
button to select the SYSTEM
SETUP option, then press the
ENTER button.
2
Press the SET/TRACKING + or –
button to select the CLOCK SET
option, then press the ENTER
button.
3
Press the SET/TRACKING + or –
button to set the month, then press
the ENTER button.
4
Set the day, year and time as in
step 3.
After setting the clock, date and time
starts functioning automatically.
•
NOTES: After a power failure or disconnection of the
power plug, the time display will be lost. In
this case, set the present time again if the
Auto Clock did not set correctly.
•
To move cursor backward, press the CANCEL
button.
14

TV OPERATION

1
To turn on the TV/VCR, press the POWER button.
2
Adjust the volume level by
pressing the VOL + or – button.
The volume level will be
indicated on the screen by
green bars. As the volume level
M E N U
increases, so do the number of
TIMER REC SET
TV SETUP bars. If the volume decreases, the number of green
CH SETUP
AUTO REPEAT ON OFF
bars also decreases.
SYSTEM SETUP
3
Set the TV/CATV menu option to the appropriate
+/–/ENTER/MENU
á ñ
position (See page 16).
SYSTEM SETUP
4
CLOCK SET Press the Direct Channel selection buttons to select
LANGUAGE/IDIOMA/LANGUE
AUTO CLOCK ON OFF
the channel.
STANDARD TIME
DAYLIGHT SAVING TIME
• TV mode direct channel selection
á +/–/ENTER/MENU ñ
CLOCK SET
MONTH 10
DAY 1 (WED)
YEAR 2003
12 : 00 AM
TIME
• CATV mode direct channel selection
+/–/ENTER/CANCEL/MENU
á ñ
CLOCK SET
• TO SELECT CATV CHANNELS:
MONTH 10
DAY 29 (WED)
YEAR 2003
8 : 30 AM
TIME
+/–/ENTER/CANCEL/MENU
á ñ
8 : 30 AM WED
NOTE FOR CHANNELS 1-12:
If only 1 or 2 buttons are pressed,
the corresponding channel will be
selected in 2 seconds.
NOTES:
When the TV/CATV menu option is in the TV
position, all channels can be instantly selected by
using two buttons (for example, to select channel 2,
press "0", then "2". If you press only "2", channel
selection will be delayed for a few seconds). For
channels 10 and above, press the 2 digits in order.
When the TV/CATV menu option is in the CATV
position, channels can be selected as follows:
1-9 Press "0" twice, then 1-9 as needed.
Example, to select channel 2, press "002".
10-12 Press "0", then the remaining 2 digits.
Example, to select channel 12, press "012".
13-99 Press the 2 digits in order.
Example, to select channel 36, press "36".
100-125 Press the 3 digits in order.
Example, to select channel 120, press "120".
•
If a channel with no broadcast is selected,
the sound will automatically be muted.
•
If a station being viewed stops broadcasting,
the TV will automatically shut itself off after
15 minutes.
VOLUME 32
CH 012