Sony SDX-700C Product Specifications Manual page 146

6.Command Specification
0Dh
00 02
0Eh
0Fh
REQUEST SENSE returns the CHECK CONDITION status only to report fatal errors for the REQUEST SENSE
command.
For example:
The target receives a non ZERO reserved bit in the command descriptor block.
An un-recovered parity error occurs on the Data Bus.
A target malfunction prevents return of the sense data.
The Allocation Length falls between block boundaries.
Following a fatal error on REQUEST SENSE, the sense data should be considered invalid. The host may attempt
recovery by selecting the drive and issuing a BUS DEVICE RESET message directly following the IDENTIFY
message. This forces the drive to do a hard reset. If the fault persists, the host should deny access to the drive.
6-96
VOLUME OVERFLOW
END-OF-PARTITION/MEDIUM DETECTED - During Write type operation.
MISCOMPARE. Not supported by the SDX-700C
RESERVED. Not used by SDX-700C
REQUEST SENSE
SONY AIT-3 drive SDX-700 series Ver.2.1