Fortinet AP433 Installation Manual page 67

Place the 'v' component against the wall at the desired location and mark the four holes
2.
(one at each corner of the bracket) on the wall.
The bracket must be oriented such that the wider portions of the bracket are its top and bottom when
placed against the wall. This will ensure that the fully deployed AP will be oriented properly (with the
Ethernet cable leading downwards).
Remove the bracket and drill the corresponding holes. When finished, insert the plastic
3.
sheetrock anchor inserts into each hole drilled.
Place the bracket against the wall again and use the screws provided with the plastic
4.
anchors to attach it to the wall.
Using the portion of the bracket assembly that has a flat component attached to another
5.
circular portion (see
the mounting bracket by placing the bracket flat against the bottom of the AP and insert-
ing screws into the corners of the bracket portion. The holes on the bracket should corre-
spond to the holes on the bottom of the AP. See
Figure 33:
Installing the Access Point
Figure 33 on
Square Mounting Bracket
page 57), attach the OAP433e to the square portion of
Figure 34 on page 58.
57