Proprietary Telephone Settings - Panasonic KX-TD816 Operating Instructions Manual

1.2
!
!
To enter the Programming Mode
PT
Be sure the telephone is idle and on-hook.
To exit the Programming Mode
PT
When the display shows the initial programming mode;
When storing data
1-4
Operations
Technical Manuals Online! - http://www.tech-man.com

Proprietary Telephone Settings

If you use a Panasonic proprietary telephone, you can customize your telephone functions. For
example, you can change the initial settings according to your needs or the button functions on
your telephone. To program, you need to switch your telephone to the programming mode.
During the programming mode, your telephone is busy to outside callers. If you want to make
a normal call operation, you must finish the programming mode.
• This feature cannot be used with a single line telephone.
• Be sure the handset is on the cradle and the SP-PHONE button is off.
• To program, set the MEMORY switch on the proprietary telephone to "PROGRAM" or
press the PROGRAM button on the KX-T7300 series.
When you enter the Station Programming mode, the display shows the following message as
the initial programming mode.
PITS-PGM NO?
The display also gives you helpful or stored data information related to the programming
steps. You can also refer to the "Display Example" in the Appendix (Section 2.4).
• After programming, return the MEMORY switch to the "SET" position or press the
PROGRAM button on the KX-T7300 series.
• If you move your desk and change the extension line, reset as desired. The setting will not
remain in your telephone but will remain in the previous extension user's memory.
• During the programming mode, your extension is treated as a busy extension.
MEMORY
SET PROGRAM
Set the MEMORY switch to "PROGRAM" on the KX-T7000 series.
OR
Press the PROGRAM button on the KX-T7300 series.
MEMORY
SET PROGRAM
Set the MEMORY switch to "SET" on the KX-T7000 series.
OR
Press the PROGRAM button on the KX-T7300 series.
After pressing the STORE button to store data, you may hear one of the following tones.
— Confirmation tone (1 beep): storage is completed.
— Confirmation tone (2 beeps): the data is the same as the last entry.
— Alarm tone (3 beeps):
PROGRAM
or
PROGRAM
or
the entry is not valid.
Programming is completed
and the normal call operation
resumes.