Wolf icbci365t Installation Manual page 2

INDUCTION AND ELECTRIC COOKTOPS
Contents
Induction and Electric Cooktops
2
Specifications
2
Installation
5
Troubleshooting
5
Features and specifications are subject to change at any
time without notice.
Important Note
To ensure this product is installed and operated as safely
and efficiently as possible, take note of the following types
of highlighted information throughout this guide:
IMPORTANT NOTE highlights information that is especially
important.
CAUTION indicates a situation where minor injury or product
damage may occur if instructions are not followed.
states a hazard that may cause serious injury or
WARNING
death if precautions are not followed.
IMPORTANT NOTE: Save these instructions for the local
electrical inspector.
|
2 English
Product Information
Important product information including the model and
serial number are listed on the product rating plate. The
rating plate is located on the bottom of the cooktop. Refer
to the illustration below.
If service is necessary, contact Wolf factory certified service
with the model and serial number.
RATING PLATE RATING PLATE
Induction cooktop. Electric cooktop.
SPECIFICATIONS
Installation Requirements
A minimum height clearance of 159 mm is required from the
top of the countertop to any combustible surface directly
below the cooktop.
Clearance is required for the power inlet box located at the
right rear of induction and electric cooktops. Refer to the
illustration below for dimensions.
Refer to the illustrations on pages 3–4 for additional
minimum clearances. Installation dimensions are the same
for induction and electric cooktops of the same width.
WARNING
Failure to locate the cooktop without proper clearances
will result in a fire hazard.
32 mm
56
mm
38 mm
84
mm
40
mm
Power inlet box clearance.
FLUSH INSTALLATION
Contemporary induction and electric cooktops can be
mounted flush with the top of the countertop, or as a frame-
less installation sitting on top of the countertop surface. If
the cooktop is to be mounted flush with the countertop, a
recessed area surrounding the cooktop cut-out must be
provided. Wolf downdraft systems cannot be used with
contemporary induction and electric cooktops.
An installation kit and instructions required for a flush
installation are provided with the contemporary cooktop.
CAUTION
Flush installation is intended for granite, solid surface
or stone countertop surfaces only.
MULTIPLE COOKTOPS
When multiple cooktops or modules are installed side by
side, the countertop cut-out width is determined by adding
the width of each unit, then subtracting 25 mm. Refer to the
illustration below.
Contemporary induction and electric
IMPORTANT NOTE:
cooktops are not designed to be installed in combination
with other cooktops.
64 mm
495 mm
CUT-OUT
DEPTH
64 mm
CUT-OUT WIDTH
(COMBINED WIDTH OF COOKTOPS
MINUS 25 mm)
Countertop cut-out.