Login And Logout; Operator Registration - Panasonic WJ-SX650 Operating Instructions Manual

LOGIN AND LOGOUT

■ Operator Registration

Before logging into the system, operator registration is required. Operator registration is performed in "Operator" – "Operator" of
WJ-SX650 Series Administrator Console. The factory default of operator information is as follows.
Operator No. User ID
1 650
2 1
3 100
4 101
5 102
6 103
• Operator No.: Number given for operator registration.
Up to 59 operators can be registered.
• User ID: ID number of operator controlling this unit. 1 to
99998 are available.
Note: Begin the entry with a numeric other than "0".
• Password: For login, a password is checked as well as
a User ID. Up to 5 digits are available.
Note: To protect system controllers from misuse, be
sure to change the factory default passwords.
• Level: An operator's restrict level. 1 to 5 are available. 1
is the highest, and 5 is the lowest.
Note: Desired functions can be assigned to each level
in "Operator" – "Level Table" of WJ-SX650 Series
Administrator Console.
• Priority: Operator priority given to control a monitor,
camera, or recorder selected by another operator. 1 to
99 are available. 1 is the highest, and 99 is the lowest.
• Camera Access: View and control can be enabled or
disabled for each camera.
VIEW & OPERATE: An operator can display the select-
ed camera image on the selected monitor. The
operator can also control the camera.
VIEW: An operator can display the selected camera
image on the selected monitor, but cannot control
the camera.
- -: The operator can neither display the selected cam-
era image on the selected monitor nor control the
camera.
Password Level
650 1
12345 1
100 2
101 3
102 4
103 5
Priority Camera Access
1 View & Operate
(All cameras)
1 View & Operate
(All cameras)
5 View & Operate
(All cameras)
10 View & Operate
(All cameras)
30 View & Operate
(All cameras)
50 View & Operate
(All cameras)
• Recorder Access: View and control can be enabled or
disabled for each recorder.
VIEW & OPERATE: An operator can display the select-
ed recorder image on the selected monitor. The
operator can also control the recorder.
VIEW: An operator can display the selected recorder
image on the selected monitor, but cannot control
the recorder.
- -: The operator can neither display the selected
recorder image on the selected monitor nor control
the recorder.
• Monitor Access: Control can be enabled or disabled
for each monitor.
Notes:
• Monitor Access is set for each DATA port.
Operators logging into the system from the same
DATA port have the common setting.
• Monitor Access setting is not applied for operators
logging into the system from the PC connected to
the SERIAL port.
• Monitor Access setting is performed in "Controller" –
"Monitor Access" of WJ-SX650 Series Administrator
Console.
Recorder Access
View & Operate
(All recorders)
View & Operate
(All recorders)
View & Operate
(All recorders)
View & Operate
(All recorders)
View & Operate
(All recorders)
View & Operate
(All recorders)
55