Step 2 - Inserting Batteries Into The Remote Control; Step 3 - Demo Function - Panasonic SC-PM21 Operating Instructions Manual

Optional antenna connection Optional antenna connection
FM outdoor antenna
• Never use an outdoor antenna during a lightning storm.
• You can connect the FM outdoor antenna for better reception. Please consult your dealer for installation.
• Disconnect the FM indoor antenna if an FM outdoor antenna is installed.
• Connect the AM outdoor antenna without removing the AM loop antenna. Run 5 to 12 m vinyl-covered wire horizontally along
a window or other convenient location.
Step 2 Step 2
- Inserting batteries into the remote control - Inserting batteries into the remote control
S S tep tep 3 3
- DEMO function - DEMO function
AM outdoor antenna
AM loop antenna
(included)
■ Batteries
• Insert so the poles (+ and –) match those in the remote control.
• Remove if the remote control is not going to be used for a long period of time.
Store in a cool, dark place.
• Do not use rechargeable type batteries.
• Mishandling of batteries can cause electrolyte leakage which can damage
items the fl uid contacts and may cause a fi re.
Do not:
• mix old and new batteries.
• use different types at the same time.
• heat or expose to fl ame.
• take apart or short circuit.
• attempt to recharge alkaline or manganese batteries.
• use batteries if the covering has been peeled off.
■ Use
• Aim at the remote control sensor, avoiding obstacles, at a maximum range of
7 m directly in front of the unit.
Refer to page 6 for remote control signal sensor position.
When the unit is fi rst plugged in, a demonstration of its functions may be shown
on the display.
If the demo setting is off, you can show a demonstration by selecting "DEMO
ON".
Press and hold [STOP 7, -DEMO].
The display change each time the button is held down.
DEMO OFF DEMO ON
While in standby mode, select "DEMO OFF" to reduce power consumption.
AM outdoor antenna
(not included)
5
RQT7903