Electrical Connection - Miele PT 5136 OS Operating And Installation Instructions

Vented tumble dryer
Table of Contents

Advertisement

Electrical connection

,
All electrical work must be
carried out by a suitably qualified
and competent person in
accordance with current local and
national safety regulations (BS 7671
in the UK).
This machine is supplied with a
connection cable without a plug for
connection to a suitable connection
socket or isolator switch.
The machine must only be operated
with the voltage, frequency and fuse
rating shown on the data plate supplied
with the machine. Please ensure these
match the site mains supply.
We recommend connecting the
machine to the power supply via an
IP44 plug and socket which must be
easily accessible for servicing and
maintenance work after the machine
has been installed.
For hard-wired machines, connection
must be made via a suitable mains
switch with all-pole isolation which
when in the off position ensures a 3 mm
gap between all open contacts.
For extra safety and protection we
recommend connecting the machine by
a 30 mA residual current device (RCD).
An electrical safety test must be carried
out after installation and after any ser-
vice work.
The mains connection cable may only
be replaced by an original Miele spare
part.
Installation and connection
,
If the machine is disconnected
from the electricity supply adequate
measures must be taken to ensure
that the machine cannot be
reconnected to the electricity supply
until all work has been carried out.
,
This machine can be converted
to a different voltage. Please
observe the switching instructions
given on the wiring diagram.
Conversion may only be carried out
by a Miele authorised service dealer
or Miele technician.
If the machine has been converted
the heater rating must also be
adapted.
,
The machine must be
permanently connected to the
electricity supply to enable the
programme to complete and to
enable the load to cool down after
drying. For this reason, it must not
be connected to devices such as
timers which would switch it off
automatically.
WARNING
THIS MACHINE MUST BE
EARTHED
49

Advertisement

Table of Contents
loading

Table of Contents