Operation; Turning The Power On; Banknote Physical Condition Selector; Counting Mode - AccuBANKER AB-5000 MG/UV User Manual

Operation

Turning the Power ON

To start operating the unit, turn it on by pressing the power switch located in the back.

Banknote Physical Condition Selector

The Physical Condition level indicator should be lit in the middle position when the power is on. Change
the level of this function by pressing the Banknote Physical Condition Selector as follows (in case the
error message “Ed” is displayed frequently).
a) For notes that are stained or printed dark, set the level indicator in the darker position.
b) For notes that are new or printed light, set the indicator in the lighter position.

Counting Mode

The unit can work in two modes, free counting mode and batch counting mode.
Free Counting Mode
In this mode the machine counts all bank notes in the hopper.This mode will be set in case the
“ blank ” is selected on the Batch Number display by pressing the Batch Function button.
Batch Counting Mode
In this mode the machine counts the batch of bank notes assigned by the user.This counting mode
may be set by entering a quantity (any number up to 999 except “
Display. Before beginning the counting function, use the Batch Function button or keypad to set the
selected number or the “
Note:
In the auto starting mode the next counting will start automatically by only removing the
counted batch notes from the stacker. In case the counting stops before the preset number has
been reached, refill the hopper.The machine will continue counting automatically.
blank ” , and then begin counting normally.
blank ”) on the Batch Number
#