HP 5120 EI Switch Series Configuration Manual page 250

[Switch-ui-vty0-4] protocol inbound ssh
[Switch-ui-vty0-4] quit
# Configure a local user named client002 with the password being aabbcc and the service type being
SSH.
[Switch] local-user client002
[Switch-luser-client002] password simple aabbcc
[Switch-luser-client002] service-type ssh
[Switch-luser-client002] quit
# Configure the user authentication method as password and service type as SFTP.
[Switch] ssh user client002 service-type sftp authentication-type password
Establish a connection between the SFTP client and the SFTP server
2.
NOTE:

The device support many types of SFTP client software. The following uses PSFTP of PuTTy Version 0.58 as an
example.

PSFTP supports only password authentication.
# Establish a connection to the remote SFTP server.
Run the psftp.exe to launch the client interface as shown in
open 192.168.1.45
Enter username client002 and password aabbcc as prompted to log in to the SFTP server.
Figure 71 SFTP client interface
Figure 71, and enter the following command:
240