HP 5120 EI Switch Series Configuration Manual page 164

# Enable port security.
[Switch] port-security enable
# Add five OUI values.
[Switch] port-security oui 1234-0100-1111 index 1
[Switch] port-security oui 1234-0200-1111 index 2
[Switch] port-security oui 1234-0300-1111 index 3
[Switch] port-security oui 1234-0400-1111 index 4
[Switch] port-security oui 1234-0500-1111 index 5
[Switch] interface gigabitethernet 1/0/1
# Set the port security mode to userLoginWithOUI.
[Switch-GigabitEthernet1/0/1] port-security port-mode userlogin-withoui
Verify the configuration.
4.
After completing the configurations, you can use the following command to view the configuration
information of the RADIUS scheme named radsun:
<Switch> display radius scheme radsun
SchemeName : radsun
Index : 1
Primary Auth Server:
IP: 192.168.1.2
Encryption Key : N/A
Primary Acct Server:
IP: 192.168.1.3
Encryption Key : N/A
Second Auth Server:
IP: 192.168.1.3
Encryption Key : N/A
Second Acct Server:
IP: 192.168.1.2
Encryption Key : N/A
Auth Server Encryption Key : name
Acct Server Encryption Key : money
Accounting-On packet disable, send times : 5 , interval : 3s
Interval for timeout(second)
Retransmission times for timeout
Interval for realtime accounting(minute)
Retransmission times of realtime-accounting packet
Retransmission times of stop-accounting packet
Quiet-interval(min)
Username format
Data flow unit
Packet unit
Use the following command to view the configuration information of the ISP domain named sun:
<Switch> display domain sun
Domain : sun
State : Active
Access-limit : 30
Type : standard
Port: 1812
Port: 1813
Port: 1812
Port: 1813
: 5
: 5
: 15
: 5
: 500
: 5
: without-domain
: Byte
: one
154
State: active
State: active
State: active
State: active