Configuring A Pppoe Session; Resetting A Pppoe Session - HP MSR Router Series Wan Access Configuration Manual

Step
9. Set the auto-dial interval.
10. Set the MTU for the dialer
interface

Configuring a PPPoE session

Step
1. Enter system view.
2. Enter Layer 3 Ethernet
interface/subinterface, Layer 3
virtual Ethernet
interface/subinterface, VLAN
interface view.
3. Create a PPPoE session and specify a
dialer bundle for the session.

Resetting a PPPoE session

After you reset a PPPoE session in permanent mode, the device establishes a new PPPoE session when the
autodial timer expires.
Command
dialer timer autodial autodial-interval
mtu size
Command
system-view
interface interface-type
interface-number
pppoe-client dial-bundle-number
number [ no-hostuniq ]
53
Remarks
The default setting is 300
seconds.
In permanent or diagnostic
mode, DDR starts the auto-dial
timer after the link is
disconnected and originates a
new call when the auto-dial
timer expires.
HP recommends that you set a
shorter auto-dial interval for
DDR to soon originate a new
call.
By default, the MTU on a dialer
interface is 1500 bytes.
The dialer interface fragments
a packet that exceeds the
configured MTU, and adds a
2-byte PPP header and a 6-byte
PPPoE header to each
fragment. You should modify
the MTU of a dialer interface to
make sure the total length of
any fragment packet is less
than the MTU of the physical
interface.
Remarks
N/A
N/A
By default, no PPPoE
sessions are created.
The number argument in
this command must take the
same value as the
configured dialer interface
number.