Rack-Mounting The 48G Model/48G Taa Model Switch - HP 5830 series Installation Manual

Figure 12 Attaching the front mounting brackets and the chassis rails to the chassis

Rack-mounting the 48G model/48G TAA model switch

To attach the slide rails to the rack:
1. Identify the rack attachment position for the slide rails.
2. Install cage nuts (user-supplied) in the mounting holes in the rack posts.
3. Align the screw holes in one slide rail with the cage nuts in the rack post on one side, and use
screws (user-supplied) to fix the slide rail to the rack, as shown in
4. Repeat the preceding step to attach the other slide rail to the rack post on the other side. Keep
the two slide rails at the same height so the slide rails can fit into the chassis rails.
Figure 13 Installing the slide rails
Mounting the switch on the rack requires two persons.
To mount the switch in the rack:
1. Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
13
Figure 13.