Turning Off The Power With The Sleep Timer - JVC RX-5032VSL Instructions Manual

Basic Operations
Turning Off the Power
with the Sleep Timer
You can fall asleep while listening to music—Sleep Timer.
A/V CONTROL
RECEIVER
1 3
2
4 5 6
7/P 8 9
10 0 10
TA/NEWS/INFO
DISPLAY MODE
Press SLEEP on the remote control repeatedly.
• The SLEEP indicator lights up on the display.
Each time you press the button, the shut-off time changes in
10 minute intervals as follows:
10 20 30
0
(Canceled)
When the shut-off time comes, the receiver turns off
automatically.
To check or change the shut-off time, press SLEEP once.
The remaining time (in minutes) until the shut-off time
appears.
• To change the shut-off time, press SLEEP repeatedly.
To cancel the Sleep Timer, press SLEEP repeatedly until
"SLEEP 0MIN" appears on the display. (The SLEEP indicator
goes off.)
• Turning off the power also cancels the Sleep Timer.
14
SLEEP
40 50 60
70
90 80
Basic adjustment auto memory
This receiver memorizes sound settings for each source
when—:
• you turn off the power,
• you change the source, and
• you assign the source name.
When you change the source, the memorized settings for
the newly selected source are automatically recalled.
The following can be stored for each source:
• Input attenuator mode (see page 18)
• Tone adjustment (see page 20)
• Speaker output level (see page 20)
• Surround/DSP mode selection (see pages 26 and 27)
• RX-6030VBK and RX-6032VSL only:
BASS BOOST (see page 18)
Notes:
• You cannot assign and store different settings for digital input
mode and analog input mode.
• If the source is FM or AM, you can assign a different setting for
each band.
For recording
You can record any sources playing through the receiver to
a cassette deck (or a CD recorder) connected to the
TAPE/CDR jacks and the VCR connected to the VCR jacks
at the same time.
While recording, you can listen to the selected sound
source at whatever sound level you like without affecting
the sound levels of the recording.
Note:
The output volume level, tone adjustment (see page 20), and
Surround/DSP modes (see pages 26 and 27) do not affect the
recording.