HP 2530 SERIES Installation And Getting Started Manual page 55

Hide thumbs Also See for 2530 SERIES:
Table of Contents

Advertisement

Tip
Problem
The port may be
improperly
configured, or
the port may be in
a "blocking"
state by the
normal operation
of the Spanning
Tree, LACP, or
IGMP features.
Use the switch console to see if the port is part of a dynamic trunk (through the LACP
feature) or to see if Spanning Tree is enabled on the switch, and to see if the port may
have been put into a "blocking" state by those features. The show lacp command displays
the port status for the LACP feature; the show spanning-tree command displays the port
status for Spanning Tree.
Also check the Port Status screen using the show interfaces command to see if the port
has been configured as "disabled".
Other switch features that may affect the port operation include VLANs and IGMP. Use
the switch console to see how the port is configured for these features.
For software troubleshooting tips, see the chapter "Troubleshooting" in the Management
and Configuration Guide, which is on the HP Web site at
support.
Ensure also, that the device at the other end of the connection is indicating a good link
to the switch. If it is not, the problem may be with the cabling between the devices or the
connectors on the cable.
Diagnosing with the LEDs
Solution
www.hp.com/networking/
Troubleshooting
4-7

Advertisement

Table of Contents
loading

Table of Contents

Save PDF