Setting To Initial Set - Panasonic AW-E600 Operating Instructions Manual

SETTING TO INITIAL SET

Setting to initial set
In case of the wrong setting in any use mode, take the
following steps to return to the initial settings.
(1) Select [Initialize Data] on the main menu screen of
each Use Mode. (See page 29.)
Press the YES/ABC switch, then [Initialize Data]
screen shown for about 10 seconds.
(2) Press the YES/ABC switch within about 10 seconds
to return to the initial settings, the existing settings
q
** Initialize Data **
(Halogen Mode)
Do you want to
initialize Halogen
Mode settings?
O.K. : YES SW
Cancel : NO SW
are initialized, the screen shown at w, and the cam-
era returns to main menu.
(3) If the NO/BAR switch is pressed, or if the YES /ABC
switch is not pressed, within about 10 seconds, the
screen shown at e, and the camera returns to main
menu, and the existing settings are not initialized.
Note
If you are using an option card, the Option Card
Setting Submenu will not be initialized even if
"Return to Initialize" is performed.
w
Halogen Mode
Initialized
-46-
e
Halogen Mode
unchanged