HP A5120 EI Configuration Manual page 38

Far-end frame loss: 40
Reply from 0010-FC00-6512
Far-end frame loss: 0
Reply from 0010-FC00-6512
Far-end frame loss: 30
Average
Far-end frame loss: 20
Far-end frame loss rate: 25%
Send LMMs: 5
Verify the one-way DM function.
4.
After the CC function obtains the status information of the entire network, use the one-way DM function to
test the one-way frame delay of a link. For example:
# Test the one-way frame delay from MEP 1001 to MEP 4002 in service instance 1 on Device A.
[DeviceA] cfd dm one-way service-instance 1 mep 1001 target-mep 4002
Info: 5 1DM frames process is done, please check the result on the remote device.
# Display the one-way DM result on MEP 4002 in service instance 1 on Device D.
[DeviceD] display cfd dm one-way history service-instance 1 mep 4002
Service instance: 1
MEP ID: 4002
Send 1DM total number: 0
Received 1DM total number: 5
Frame delay: 10ms 9ms
Delay average: 8ms
Delay variation: 5ms
Variation average: 3ms
Verify the two-way DM function.
5.
After the CC function obtains the status information of the entire network, use the two-way DM function to
test the two-way frame delay of a link. For example:
# Test the two-way frame delay from MEP 1001 to MEP 4002 in service instance 1 on Device A.
[DeviceA] cfd dm two-way service-instance 1 mep 1001 target-mep 4002
Frame delay:
Reply from 0010-FC00-6512: 10ms
Reply from 0010-FC00-6512: 9ms
Reply from 0010-FC00-6512: 11ms
Reply from 0010-FC00-6512: 5ms
Reply from 0010-FC00-6512: 5ms
Average: 8ms
Send DMM frames: 5
Frame delay variation: 5ms
Average: 3ms
Verify the TST function.
6.
After the CC function obtains the status information of the entire network, use the TST function to test the
bit errors of a link. For example:
Near-end frame loss: 40
Near-end frame loss: 10
Near-end frame loss: 30
Near-end frame loss: 25
Near-end frame loss rate: 32%
Received: 5 Lost: 0
11ms 5ms 5ms
4ms 6ms 0ms 0ms
Received: 5
4ms 6ms 0ms
33
Lost: 0
0ms