Setup 3 Off-Line Utilities Display Format Items - HP dat72 5242 User Manual

Section 4: SCSI Bridge Electronics
If your configuration or NonStop server environment requires unique settings or special
configurations, HP can provide assistance and minor firmware configurations for specific platforms,
software or drives through the use of this menu item. This setting is factory-configured at 00001400
and you should never have to changed it. As noted, special situations may require this setting be
changed, but it is highly recommended that you contact your service provider before changing this
setting. Use the Numeric Entry Method to enter the eight-digit hex value.
2.7.3 Selecting a Baud Rate
BaudRate
9600 bps
PRESS to
Alter
BaudRate
9600 bps
PRESS to
Scroll
Figure 63
Four different baud rates are available for connecting to a serial terminal or terminal emulator: No parity, 8
data bits, 1 stop bit, and xon/xoff flow control. The 3-pin serial connector on the tape drive can connect to
a PC serial port by using a communication package such as PRO-COMM (with xon/xoff enabled) to
upgrade the flash firmware. Use the Pick Entry Method to select a baud rate.
2.8

Setup 3 Off-line Utilities Display Format Items

Enter
Set-Up 3
PRESS to
Select
Create a
CodeTape
PRESS to
Run
Figure 64
HP StorageWorks DAT 72 (Models 5242 and 5242-ACL) User's Guide
BaudRate
1200 bp s
PRESS to
Scroll
Selecting a baud rate
Drive Hdwr
Test
Test
PRESS to
press
Run
to
Exit
Load a
Set-Up 3
CodeTape
PRESS to
PRESS to
Select
Run
Setup 3 off-line utilities menu
BaudRate
2400 bps
PRESS to
Scroll
BaudRate
19K2 bps
PRESS if
Done
run
60 HP Part Number 528296-03 July 2005