Security Menu; Input Password; Password Change; Text Display - Panasonic PT-LB78E Operating Instructions Manual

SECURITY menu

Remote control
See "Navigating through the MENU" on page 29.
See "Main menu and Sub-menu" on page 30.
Entering the SECURITY menu
Every time when you apply to the SECURITY
menu, you will be asked to perform the password
operation.
PICTURE

INPUT PASSWORD

POSITION

PASSWORD CHANGE

LANGUAGE

TEXT DISPLAY

OPTION

TEXT CHANGE

SECURITY
WIRELESS
PASSWORD
RETURN
ENTER
When you apply to the SECURITY menu before you
change the password to your original, perform to input
the following factory default password operation.
Press F H G I F H G I and the ENTER button.
After you change the password
When you apply to the SECURITY menu after you
change the password to your original in the
PASSWORD CHANGE menu, input the original
password operation.
NOTE:
• The factory default password is valid until you change
the password in PASSWORD CHANGE menu.
• The entered password operations will appear as
asterisks in the box.
INPUT PASSWORD
You can activate the security system and the password
operation will be asked to perform when projecting mode
started. Unless you perform the correct password
operation, all of the button controls will be disabled
except the POWER button.
OFF Deactive
ON Active
NOTE:
• When you activated the security system, make sure to
change the password to your original for safety.
• The security system is deactivated by default and when
initialised.
Control panel
MENU RETURN
OFF
OFF
PASSWORD CHANGE
You can change the password operation to your original.
1. Press a series of button operation up to 8 as a
password by using F G I and H buttons.
2. Press the ENTER button.
3. Press the exact same series of button operation
you entered in the NEW password box for
confirmation.
If a series of button operation is incorrect, you will be
asked to perform again.
4. Press the ENTER button.
NOTE:
• The entered password operations will appear as
asterisks in the box.
• Change your password regularly.
• Do not use too simple password to guess.
TEXT DISPLAY
You can set your original text, such as company name or
URL information, to display regularly at the bottom of the
projected image while projecting.
OFF Deactive
ON Active
TEXT CHANGE
You can enter your original text up to 22 characters for
TEXT DISPLAY.
TEXT CHANGE
OK
1. Use F G I H to specify the location of the
required character and press the ENTER button.
The selected character will be displayed in the TEXT
CHANGE box.
2. Repeat step 1 until finish your original text.
To delete all the entered characters, move the cursor
to ALL DELETE and press the ENTER button.
To insert a character in the entered text line, move
the cursor to the text box to select the required place,
and press G and return to the character field.
To delete a character, press the DEFAULT button or
move the cursor to the required character then press
the DEFAULT button.
3. Select OK and press the ENTER button to set the
entered text.
Select CANCEL or press the MENU/RETURN button
to return to the previous menu without setting.
ALL DELETE
SPACE
CANCEL
E
NGLISH - 39