Setting Unit Id; Registering/Deleting/Displaying User Mode - Panasonic PT-L6510U Operating Instructions Manual

OPTION 2 settings

SETTING UNIT ID

UNIT ID is used to set projector IDs when the user
wishes to control two or more projectors either
simultaneously or separately.
SET ID
"ALL": The projectors can be simultaneously
controlled from any remote control regardless
of their ID settings.
"1": The projector can be controlled from the remote
control with its projector ID set to "1".
"2": The projector can be controlled from the remote
control with its projector ID set to "2".
"3": The projector can be controlled from the remote
control with its projector ID set to "3".
Note
• Unit ID is set to "ALL" by default. Hence ID
number need not be set when only one
projector is used.
• If the projectors are given ID numbers, their
remote controls must be assigned the same
ID numbers, respectively.
• If the unit IDs of two or more projectors are
set to "ALL", the user will not be able to
control them separately.
• The projector can be turned ON/OFF from
the remote control only if the projector ID is
set in the remote control. For the details of
projector ID setting, see page 15.
36
ALL
1
2
3
Registering/Deleting/
Displaying User Mode
(For RGB/YP P signals only)
B R
Once adjustment settings are registered with User
Mode, they are automatically loaded each time the
projector is powered up. It is not necessary to readjust
settings at every power on.
Registering User Mode
(e.g. Registering positioning data with "USER1")
1. Apply an input signal you want to register, and
then adjust the picture position, size, and others.
2. Choose "USER MODE" on "OPTION2" and press
the "ENTER" button.
USER MODE
ENTRY
SELECT ADJ
3. Choose "USER1" using the
press the "ENTER" button.
Note
• The user address has "USER1" to "USER3".
4. After recognizing the flashing of the "USER1"
address display, press the "ENTER" button again.
5. The above adjusted settings has been registered
with "USER1". Similarly you can also register
settings with "USER2" or "USER3".
Deleting User Mode
(e.g. Deleting the data of USER1)
1. Choose "USER MODE" on "OPTION2" and press
the "ENTER" button.
2. Choose "DELETE" using the
3. Choose the address ("USER1") you want to delete
data from using the
"ENTER" button.
USER MODE
ENTRY
DELETE
SELECT ADJ
4. After recorgnizing the flashing of the address
display, press the "ENTER" button again to delete
the data of the address.
Displaying User Mode
The User Mode can be displayed by following the
steps described in "SIGNAL MODE" on page 31.
USER1
ESC
or buttons and
or buttons.
or buttons and press the
USER1
USER1
ESC