LG WM3997H*A Owner's Manual page 15

INSTALLATION INSTRUCTIONS 15
Conneding 1"he Drain Line
Secure the drain hose in place to prevent moving and
leaking.
_-@ NOTE
• The drain hose should be properly secured. Failure
to properly secure the drain hose can result in
flooding and malfunction.
• Total height of the hose end should not exceed
96 inches (244.8 cm) from the bottom of the
washer.
• The drain must be installed in accordance with any
applicable local codes and regulations.
• Make sure that the water lines are not stretched,
pinched, crushed, or kinked.
Clip the end of the hose into the elbow bracket.
- Connect the elbow bracket within 4 inches (10 cm)
of the end of the drain hose. If the drain hose is
extended more than 4 inches (10 cm) beyond the
end of the elbow bracket, mold or microorganisms
could spread to the inside of the washer.
NO more than
4 inches (10 cm)
racket
2 Insert the end of the drain hose into the standpipe.
Elbow Bracket
3 Use a tie strap to secure the drain hose in place.
Clip the end of the hose into the elbow bracket.
- Connect the elbow bracket within 4 inches (10 cm)
of the end of the drain hose. If the drain hose is
extended more than 4 inches (10 cm) beyond the
end of the elbow bracket, mold or microorganisms
could spread to the inside of the washer.
NO more than
4 inches (10 cm)
racket
2 Hang the end of the drain hose over the side of the
laundry tub.
3 Use a tie strap to secure the drain hose in place.