Adjusting The Color Matching Using A Colorimeter - Panasonic PT-DW100U Operating Instructions Manual

5. Press ENTER.
• The "3COLORS:RED", "3COLORS:GREEN" or
"3COLORS:BLUE" screen will be displayed.
If you selected "7COLORS", the
"7COLORS:RED", "7COLORS:GREEN",
"7COLORS:BLUE", "7COLORS:CYAN",
"7COLORS:MAGENTA", "7COLORS:YELLOW",
or "7COLORS:WHITE" screen will be
displayed.
3COLORS:RED
RED
GREEN
BLUE
Press ◄► to adjust the values.
6.
• These values can be adjusted from 0 (off) to
2 048 (full gain). The color value being adjusted
is added or subtracted from the adjustment
color listed at the top of the menu (e.g.
3COLORS: RED)
Note
• The effects of correcting the adjustment color:
When tuning the correction color that is the same
as the adjustment color: the brightness of the
adjustment color changes.
RED: RED is added to or reduced from the
adjustment color.
GREEN: GREEN is added to or reduced from the
adjustment color.
BLUE: BLUE is added to or reduced from the
adjustment color.
• This adjustment should be carried out by a person
who is familiar with the projector or by a service
person because a high level of skill is required to
make successful adjustment.
• Pressing DEFAULT will restore the factory defaults
for all items.
• When any setting other than "OFF" has been
selected for color matching, the "COLOR
TEMPERATURE" setting is fixed at "USER1".
Adjusting the color matching
using a colorimeter
The "RED", "GREEN", "BLUE", "CYAN", "MAGENTA",
"YELLOW" and "WHITE" colors can be changed to
the desired hues using a colorimeter which is capable
of measuring the chromaticity coordinates and
luminance.
Inputting the current luminance
and chromaticity coordinates
Press ▲▼ to select "COLOR
1.
MATCHING".
DISPLAY OPTION
COLOR MATCHING
LARGE SCREEN CORRECTION
Press ◄► to select
2.
"MEASURED" or "709MODE".
3. Press ENTER.
•
Press ▲▼ to select "MEASURED
4.
2048
DATA".
0
0
5. Press ENTER.
•
6. Use the colorimeter to
measure the luminance (Y)
and chromaticity coordinates
(x, y) (If the projector is new,
these values will not need to be
changed).
Press ▲▼ to select the colors,
7.
and press ◄► to select their
values.
8. After all the data has been input,
press MENU.
•
Inputting the coordinates
of a desired color (only
"MEASURED")
Press ▲▼ to select "TARGET
9.
DATA".
OFF
OFF
The "MEASURED MODE" screen will be displayed.
MEASURED MODE
MEASURED DATA
TARGET DATA
AUTO TESTPATTERN
The "MEASURED DATA" screen will be
displayed.
MEASURED DATA
BLACK Y(RELATIVE)
x
y
RED Y(RELATIVE)
x
y
GREEN Y(RELATIVE)
x
y
BLUE Y(RELATIVE)
x
y
The "MEASURED MODE" screen will be
displayed.
MEASURED MODE
MEASURED DATA
TARGET DATA
AUTO TESTPATTERN
ON
1/2
1
0.35
0.36
1400
0.67
0.33
5099
0.35
0.63
500
0.15
0.05
ON
ENGLISH – 69