Installing On A Wall; Installing On An Electrical Box - HP 650 Installation Manual

Installing on a wall

When installing the HP 560 on a wall, ensure that the mounting surface and the fasteners you use
can support at least 0.9 kg (2 lb). Allow extra weight for cables.
1. Hold the mounting bracket, with the UP arrow pointing up, against the wall where you want
to install it. Mark the location of the screw holes (wall anchors) and the cutout area.
NOTE:
Figure 3 AP mounting bracket
1
4
5
4
1
7
1. Adapter bracket mounting holes
2. Electric box mounting holes
3. AP bracket latch
4. AP retention tabs
2. Drill two holes for the screws or wall anchors, typically 4.7 mm (3/16 inch) in diameter.
3. If necessary, drill a hole for the Ethernet cable in the marked cutout area.
Alternately, you can feed the Ethernet cable from above and through the AP cable channel.
4. If you are using wall anchors, insert them into the holes that you drilled, and tap them flush
with the wall surface.
5. If you are running the Ethernet cable through the wall, pull it through the hole in the wall and
the AP bracket.
6. Use the mounting screws to attach the AP bracket to the wall.
7. Proceed to

Installing on an electrical box

1. Disconnect power from the electrical box and take any other needed security precautions.
2. Remove the electrical box cover and any contents.
3. Pull the Ethernet cable down into the box and through the hole in the AP bracket.
4. Hold the AP bracket with the UP arrow pointing up against the box, and use the countersunk
screws to attach the AP bracket.
5. Proceed to
8 Installing the HP 560
The holes that you use depend on the mounting surface. See
2 3
6
"Attaching the HP 560" (page
"Attaching the HP 560" (page
8
1
4
5
6
4
1
8
2
5. Drywall mounting holes
6. Cutout area
7. AP bracket lock tab
8. T-bar clip screw holes
10).
10).
Figure 3 (page 8).