Wall Installation - HP E-MSM466-R Install Manual

9. Rotate the E-MSM466-R body up or down to the desired position and then tighten the bracket
bolts to 50 kgf-cm (43.4 lbf-in).

Wall installation

1. Hold the mount bracket as a drilling template against the wall at the desired position with the
two bracket bolt holes (4) facing the left and right sides. Mark four holes for the screws (wall
anchors).
Figure 7 Mounting bracket
4
1. Screw holes (x4) (screws shown)
2. Pole clamp slot (x4)
3. Pole cut out
2. Drill four holes for the wall anchors, typically 4.7 mm (3/16 inch) in diameter.
3. Insert the anchors and tap them flush with the wall surface.
4. Screw the E-MSM466-R bracket to the wall.
5. Refer to Figure 8. Locate the two bracket bolts (5), the two lock washers, and the four flat
washers. Onto each bracket bolt (5), thread a lock washer followed by a flat washer. Push
both washers against the bracket bolt (5) head.
6. Hold the E-MSM466-R up to the mount bracket (4), angling the E-MSM466-R so that it is
parallel with the mount bracket (4) and the bolt holes align.
7. Have an assistant hold the E-MSM466-R in place with the bolt holes aligned. On one side of
the E-MSM466-R, slide in a second flat washer between the bracket (4) and the bracket post
(6), and while holding the edge of this flat washer, thread the bracket bolt (5) (with the lock
washer and flat washer already threaded) through the hole in the bracket (4), through the
1 2 3
4. Bracket bolt hole (x2)
Mounting the E-MSM466-R 13