Connecting The Plug To The Wall Outlet; How To Turn The Power On; Battery Installation; Battery Cautions - Panasonic TX-47P950A Operating Instructions Manual

Before Operating This Set

Connecting the Plug to the Wall Outlet

How to Turn the Power On

Power Indicator
Power Switch
Notes:
• When in the Stand-by condition (Refer to page 11), it is also possible to turn the TV set on by pressing any of the "Direct
Programme Number Selection buttons" (0 - 9) or "Programme Number Up or Down buttons" on the TV set or on the Remote
Control.
• If the Wall Outlet is switched OFF or the Main Plug is unplugged, when the TV set is again turned ON (by either connecting the
Main Plug to the Wall Outlet or switching the Wall Outlet ON), it will have returned to the original state.

Battery Installation

1
Open the cover.
Pull and hold the hook, then open
the battery cover.
Note:
• Do not use rechargeable (Ni-Cd) batteries.
• They are different in shape and performance and may fail to ensure correct operation.

Battery cautions

The incorrect use of batteries can cause electrolyte leakage which will corrode the Remote Control or cause the batteries to burst.
Observe the following precaution:
1. Batteries shall always be replaced as a pair. Always use new batteries when replacing the old set.
2. Do not combine a used battery with a new one.
3. Do not mix battery types (example:"Zinc Carbon" with "Alkaline").
4. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.
5. Battery replacement is necessary when remote control acts sporadically or stops operating the TV set.
6
Notes:
• Main plug types vary between countries. The main plug shown at left may
therefore not be the type fitted to your set.
• The On/Off switch on this model does not fully disconnect the TV from the
mains supply.
Power OFF
Note: Even when the Power Switch is "OFF", the TV set will still
Push the Power switch on Television to turn the set on.
Power ON
2
Batteries: Use two "R6 (AA)" size batteries.
Insert the batteries ensuring the correct polarities.
This is identifiable by the "+" and "–" symbols on
the batteries and inside the battery compartment.
Two "R6 (AA)" size
Power Indicator
No light: Power OFF condition
consume a small amount of power.
Power Indicator
No light: Normal viewing condition
Red : Stand by
3
Replace the cover.