Connecting The Aerial Cable To The Rf In Terminal; Connecting Headphones - Panasonic TX-47P950A Operating Instructions Manual

Connecting the Aerial Cable to the RF in Terminal

VHF Aerial
Mixer
75 Ohm
Coaxial Cable
To obtain optimum quality picture and sound, an Aerial, the correct cable (75 Ohm coaxial) and the correct terminating plug are
required.If a communal Aerial system is used, you may require the correct connection cable and plug between the wall Aerial socket
and your set.
Your local Television Service Centre or Dealer may be able to assist you in obtaining the correct Aerial system for your particular area
and accessories required.
Any matters regarding Aerial installation, upgrading of existing systems or accessories required, and the costs incurred, are the
responsibility of you, the Customer.

Connecting Headphones

Connect headphones as follows.
(Optional)
(not supplied)
You can listen to sound from the headphones plugs as shown below.
Screen condition
Single
A
picture/Teletext
Picture in
A
Picture
Picture and
A
Picture
Headphones plug:
When a Headphones plug is inserted into the Headphones socket, all
speakers will be automatically disconnected; only the Headphones will
function.
Use Volume Up "+" or Down "-" button to control volume level.
UHF Aerial
RF in Terminal
(3.5mm Plug)
Speaker
Headphones
Sound
A A
(Stereo) (Stereo)
A A
(Stereo) (Stereo)
B
A A
B
(Stereo) (Stereo)
Before Operating This Set
RF in
Terminal
S-VIDEO
Y Y
VIDEO
MONO MONO P B MONO B P
L
AUDIO P R R P
R
MONITOR AV1 I COMPONENT I COMPONENT
OUT IN AV2 IN AV4 IN
Coaxial Aerial Plug
Monitor
Output
A
(Stereo)
A
(Stereo)
A
(Stereo)
Coaxial aerial plug
75 Ohm Coaxial Cable
5