Compatibility; Ecp Error - Honeywell ADEMCO 6271 Series Installation And Setup Manual

TouchCenter Installation and Setup Guide

Compatibility

The below listing identifies the alarm systems that the TouchCenter
can interface with, the maximum number of TouchCenters that can
be used with each system, and the minimum alarm panel software
revision level for compatibility.
MAXIMUM NUMBER
ALARM SYSTEM OF TOUCHCENTERS
VISTA-15P
VISTA-20P
VISTA-20P
VISTA-20PS
VISTA-20PS
VISTA-128BP
VISTA-128FBP
VISTA-250BP
VISTA-250FBP
VISTA-250FBP
• On all panels except the residential panels, you may obtain the
software revision level of the alarm panel by entering the program
mode and then entering #92 on the keypad. The second line of the
keypad displays the software revision level (without the decimal
point).
• The keypad sound suppression feature available in some commercial
panels is not compatible with the TouchCenter.

ECP Error

The message "ECP Error" will be displayed at the top of the screen (except for
the Home screen) when the
alarm panel. This may be caused by an incorrect ECP address in the
TouchCenter
or because AUI type devices have not been enabled in the
panel. While this message is being displayed, you must use the
TouchCenter
default code of "4140" any time the
authorized code.
1–2
2
2
4
2
4
3
3
3
1
3
TouchCenter
cannot communicate with the
TouchCenter
MINIMUM SOFTWARE
REVISION LEVEL
3.0
3.0
5.0
3.0
5.0
2.4
1.6
2.4
1.5
2.0
requests an