• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
In This Section
o
Programming the Control
Panel
o
TouchCenter Initialization
o
How to Change the ECP
Address
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
Programming the Control Panel
The TouchCenter will not be fully operational unless its address in
the control panel has been enabled for an alpha console, AUI type
device, and assigned to a partition (where applicable). Refer to
"Compatibility" on page 1–1 of this document for the quantity of
TouchCenters that may be used and the required control panel
software revision level.
Note: When programming your control panel, if you change the zone
types for your emergency zones you may disable the emergency
buttons in the TouchCenter. The emergency buttons in the
TouchCenter are active for zone types 06 and 07 (Panic button), 08
(Medical button), and 09 (Fire button). Additionally, the Medical
button is also compatible with a zone type 15 (24-Hour Medical) for
panels that contain this zone type.
On residential control panels (VISTA-20P or equivalent), up to
four TouchCenters may be used (addresses 1, 2, 5 and 6). Addresses 1
and 2 (in field *189) are enabled by default. If the defaults have been
changed, enable these addresses (in field *189) using an alpha-
keypad and the Data Field Programming procedures located in the
panel Installation and Setup Guide.
On commercial control panels (VISTA-128BP, VISTA-128FBP,
or equivalent), addresses 1, 2, and one address from 3 through 30
may be used for the TouchCenter. These addresses in the control
panel are normally not defaulted for AUI type devices. To enable the
S E C T I O N
Initial Setup
o
How to Access the Central
Station Screen
o
TouchCenter Setup
o
Setting Operating Modes
4
4–1