Table of Contents
Advertisement
Lamp Replacement
5
Install the new Lamp unit.
Remove the Lamp from the LCD Projector and
install a new lamp unit (ET-LA059X.)
• Do not drop, impact of dropping may cause Lamp to
explode.
6
Replace the Lamp unit screws.
Replace the Lamp unit screw and the Lamp
cover screws using a screwdriver to tighten.
• Properly dispose of old Lamp.
Note
• Attach the lamp unit and lamp unit housing door
securely. If the lamp unit and lamp unit housing door
are not attached securely, the protective circuit will be
activated and the power will not turn on.
7
Plug the LCD Projector back in by inserting the
Power cord in LCD Projector AC socket and
set the Main Power Switch to ON.
8
For lamp replacement, please see the included
separate sheet to perform the reset procedure.
Lamp unit
Screw driver
Lamp cover
screw
54
Advertisement
Table of Contents
