Operation; Forward/Reverse Lever; Fastening Screws; Clutch Torque Setting - Panasonic EY6803 Operating Instructions Manual

. OPERATION

Chuck
NOTE: Grease for bit
Grease the oval indentation
on the bit with the supplied
grease at least once a month.
1. To insert the bit
1-1. Insert a bit into the mounting hole,
and turn it slightly to locate an
engaged position.
1-. At the engaged position, push the
bit as far as it goes. Make sure that
the bit is fixed by pulling it.
SDS PLUS type
2. To remove the bit
-1. Depress the chuck cover and pull
the bit.

Fastening Screws

Use a bit adapter (standard) and bit.
1. Remove the bit adapter from the
bit adapter holder on the main unit.
. Pull the bit holder. (2)
3. Insert the bit. (3)
4. Make sure the bit is
inserted firmly by pulling
it lightly.
5. Insert the bit adapter into
the mounting hole and
turn to locate an engaged
position.
6. At the engaged position,
push in as far as it goes.
• Make sure it does not move by
pulling it lightly.
EY6803(EU).indb 5
shank
Bit
holder
- 5 -

Forward/Reverse Lever

Forward
Lock
Be sure to set the switch in the center
to lock it after use.
Operate the Forward/Reverse lever
after the motor rotation is completely
stopped.
Hammering/Drilling Switching Lever
NOTE: Operate the mode change af-
ter the motor rotation is com-
pletely stopped.
Position of
Action mode
switching lever
Rotation with
hammering
Rotation only

Clutch Torque Setting

Adjust the torque to one of the 5
clutch settings or " " position.
CAUTION:
Test the setting before actual
operation.
Set the scale at this mark (
Variable Speed Control Trigger
To set the center of a hole, pull the trigger
slightly to start the drill rotation slowly.
The more the speed control trigger is
pulled, the higher the speed becomes.
Reverse
Operation
Concrete
Drilling,
Block Drilling
Screw
Fastening,
Metal Drilling
).
2006/04/10 9:41:30