Cordless Hammer Drill Driver Operating Instructions Model No: EY6932 IMPORTANT This manual contains safety information. Read manual completely before first using this product and save this manual for future use.
. GENERAL SAFETY RULES FOR ALL BATTERY OPERATED TOOLS WARNING! Read and understand all instructions. Failure to follow all instructions listed below, may result in electric shock, fire and/or serious personal injury. SAVE THESE INSTRUCTIONS Work Area 1) Keep your work area clean and well lit.
13) Do not force tool. Use the correct tool for your application. The correct tool will do the job bet- ter and safer at the rate for which it is designed. 14) Do not use tool if switch does not turn it on or off. A tool that cannot be controlled with the switch is dangerous and must be repaired.
Page 4
8) During charging, the charger may become slightly warm. This is normal. Do not charge the bat- tery for a long period. Symbol meaning Direct Current no load speed revolutions or …/min reciprocation per minutes Forward Rotation Reverse Rotation Rotation with Hammering Rotation only WARNING;...
Page 5
7) An extension cord should not be used unless absolutely necessary. Use of improper extension cord could result in a risk of fire and electric shock. If extension cord must be used, make sure: a. that pins on plug of extension cord are the same number, size and shape as those of plug on charger.
. FUNCTIONAL DESCRIPTION Clutch handle Keyless drill chuck Variable speed control trigger 15.6V Battery pack (EY9231) . ASSEMBLY Attaching or removing bit Note: When attaching or removing a bit, disconnect battery pack from tool or place the switch in the center position (switch lock). This tool is equipped with a keyless drill chuck.
Attaching or removing battery pack 1. To connect the battery pack: Insert the battery pack. It snaps into place to indicate proper connection. 2. To remove the battery pack: Press the two buttons on the sides of the battery pack. Slide the bat- tery pack out of the tool body.
Bit-locking function 1. With the trigger switch not engaged and a screwdriver bit locked in place, the tool can be used as a manual screwdriver (up to 22.6 Nm, 230 k f-cm, 199 in-lbs). There will be a little play in the chuck, but this is not a malfunction.
Battery pack Battery charger 3. During charging, the charging lamp will be lit. When charging is completed, an internal electronic switch will au- tomatically be triggered to prevent overcharging. Charging will not start if the battery pack is warm (for example, immedi- ately after heavy-duty operation).
CAUTION: USE AT LOW SPEED WHEN STRONG FORCE IS NEEDED DURING OPERATION. (Using at high speed while a strong force is applied may cause a motor breakdown.) Use the following as a guide to select low or high speed for the job. EY6932 MATERIAL/ MORTAR / CONDITION BRICK ø...
Charging time NOTE: This chart may include models that are not available in your area. Please refer to the catalogue. EY6932 M3 ~ M6 ø 2.1 ~ ø 6.8 mm (5/64" ~ 17/64") ø 4 ~ ø 6 mm (5/32" ~ 15/64") ø...
Page 12
30-DAY QUALITY SATISFACTION GUARANTEE: If you are dissatisfied with any Panasonic Cordless Power Tool for any reason, simply return it to the place of purchase with a dated proof of purchase, in the original packaging, with all accessories, parts and instructions, within 30 days of the date of purchase, for a full refund, or call Panasonic at 201-392-6655.