Toyota 2004 Prius Owner's Manual page 194

(c) Erasing the entire HomeLink
memory (all three programs)
To erase all previously programmed codes
at one time, press and hold down the 2
outside buttons for 20 seconds until the
indicator light flashes.
If you sell your vehicle, be sure to erase
the programs stored in the HomeLink
memory.
194
R
CAUTION
D
When programming the HomeLink
Universal Transceiver, you may be
operating a garage door or other
device. Make sure people and ob-
jects are out of the way of the ga-
R
rage door or other device to pre-
vent potential harm or damage.
D
Do not use this HomeLink
sal Transceiver with
door opener that lacks the safety
stop and reverse feature as re-
quired by federal safety standards.
(This includes any
opener model manufactured before
April 1, 1982.) A garage door open-
er which cannot detect an object
(signaling the door to stop and re-
verse), does not meet current feder-
al safety standards. Using a garage
door opener without these features
increases risk of serious injury or
death.
This device complies with part 15 of the
FCC Rules and with RSS−210 of the
Industry Canada. Operation is subject to
R
the following two conditions: (1) This
device may not cause harmful interfer-
ence, and (2) this device must accept
any interference that may be received,
including interference that may cause
undesired operation.
WARNING: This transmitter has been
R
Univer-
tested and complies with FCC and
any garage
Industry Canada
Changes or
pressly approved by the party respon-
sible for compliance could void the
garage door
user's authority to operate the device.
DOC/MPAC rules.
modifications not ex-