Toyota 2004 Prius Owner's Manual page 164

26p141a
(b) Presetting a station
1. Tune in the desired station.
2. Touch one of the station selector
switches (1−6) and hold it until a
beep is heard. This sets the station
to the switch and the frequency ap-
pears on the switch.
Each switch can store FM1, FM2 and AM.
To change the preset station to a different
one, follow the same procedure.
The preset station memory is cancelled
when the power source is interrupted by
battery disconnection or a blown fuse.
164
(c) Selecting a station
Tune in the desired station using one of
the following methods.
Preset tuning: Touch the switch (1−6) for
the station you want. The switch (1−6) is
highlighted in green and station frequency
appears on the display.
Manual tuning: Turn the "TUNE" knob
briefly. Each time you turn the knob, the
radio will step up or down to another fre-
quency.
Seek tuning: Push the "SEEK TRACK"
button on either side. The radio will begin
seeking up or down for a station of the
nearest frequency and will stop on recep-
tion. Each time you push the button, the
stations will be searched out one after
another.
26p126
Scan tuning: Push the "SCAN" button or
touch the "SCAN" switch (AM mode only)
briefly. "SCAN" appears on the display.
The radio will find the next station up or
down the band, stay there for a few se-
conds, and then scan again. To select a
station, push the "SCAN" button a second
time.
Preset scan tuning: Push the "SCAN"
button or touch the "SCAN" switch (AM
mode only) and hold it until you hear a
beep. "P. SCAN" appears on the display.
The radio will tune in the next preset sta-
tion up or down the band, stay there for
a few seconds, and then move to the next
preset station. To select a station, push
the "SCAN" button a second time.