Convenience Box - Mercedes-Benz 2013 W218 Owner's Manual

EASY-PACK boot box (CLS Coupé)
Important safety notes
G
WARNING
When the load surface moves up, your hands
may become trapped on the frame of the
EASY-PACK boot box. There is a risk of injury.
When the load surface moves up, make sure
that your hands are not within the sweep of
the load surface. If someone becomes trap-
ped, carefully push the centre of the load sur-
face downward.
! When the EASY-PACK convenience box is
pulled out, no objects may be placed on the
frame of the box or pushed onto the frame
from above. Otherwise, the box could be
damaged.
! Sharp-edged, pointed or fragile objects
can damage the EASY-PACK boot box and
then be thrown out. There is a risk of injury.
Do not transport sharp-edged, pointed or
fragile objects in the EASY-PACK boot box.
Always store and secure these or similar
objects in the boot outside of the EASY-
PACK boot box.
!
If you exceed the maximum permitted
load of the EASY-PACK boot box, objects
can be thrown out of the EASY-PACK boot
box and strike vehicle occupants. There is
a risk of injury, particularly in the event of
sudden braking or a sudden change in
direction.
Always observe the maximum permitted
load of the EASY-PACK boot box. Always
store and secure heavy objects in the boot
outside of the EASY-PACK boot box.
The maximum permitted load of the EASY-
PACK boot box is 10 kg. With a load of above
approx. 5 kg, the bottom of the box moves
downward until it is rests on the mat of the
boot floor. Thus, overloading of the box is
avoided.
Adjusting the height to any position
X
Pull the box out by handle : in the direc-
tion of the arrow all the way to the stop.
X
Lowering the load surface: push the
centre of load surface ; down by hand in
the direction of the arrow until load sur-
face ; has reached the desired position
and the box is the desired size.
X
To raise the load surface: press switch
=.
Load surface ; of the box moves up auto-
matically.
X
To stow the box: push the box in by han-
dle : all the way to the stop.
Removing and fitting
X
To install: insert retainer ; of box : into
slots =
Stowage areas
Z
315