Yamaha 2010 V Star XVS650AZ Owner's Manual page 76

PERIODIC MAINTENANCE AND ADJUSTMENT
4. Remove the brake pedal free play
adjusting nut, and then disconnect
the brake rod from the brake cam-
shaft lever.
1. Brake pedal free play adjusting nut
2. Brake camshaft lever
3. Bolt and nut (shoe plate)
4. Brake torque rod
5. Bolt and nut (swingarm)
7
6. Brake rod
5. Remove panel A. (See page 7-7.)
6. Remove the bolts that secure the
final gear case to the swingarm.
1. Bolt
2. Final gear case
7. Lift the rear wheel off the ground
according to the procedure on
page 7-32.
8. While supporting the drive shaft,
pull the rear wheel back to remove
the following parts as an assem-
bly: wheel, wheel axle, final gear
case, and drive shaft.
TIP
Make sure to support the drive shaft as
it is being pulled out.
7-35
To install the rear wheel
1. Install the rear wheel, wheel axle,
final gear case, and drive shaft by
pushing the wheel forward and
guiding the drive shaft into the mid-
dle gear universal joint.
1. Middle gear universal joint
2. Drive shaft
2. Install the final gear case bolts.
3. Install the brake rod onto the brake
camshaft lever, and then install the
brake pedal free play adjusting nut
onto the brake rod.
4. Install the brake torque rod bolt
and nut at the brake shoe plate.
5. Install the panel.
EAU25512