Rear Seats - Skoda Rapid Spaceback Owner's Manual

Setting the armrest height

Read and observe on page 63 first.
›
To adjust the height, lift the armrest in the direction of the arrow into one of
the six locking positions » Fig. 55.
›
To fold down, lift the armrest in the direction of the arrow up to the stop and
then fold back down again.

Rear seats


Introduction
This chapter contains information on the following subjects:
Seat backrests
Fold down armrest
Seat backrests
Fig. 56 Folding the seat backrest forwards/standby position of the seat
belt
64
Using the system
Fig. 55
Raise armrest
Before folding the seat backrests forwards, adapt the position of the front
seats in such a way that they are not damaged by the folded seat backrests.
Folding forward
›
Push the headrest into the seat backrest until it clicks into position.
›
Insert the belt buckle latching element
the side panel - ready position
›
Push the release lever
A
backrest in the direction of arrow
In the undivided seat back, insert the buckle tongues
belts and the press the release handles
multaneously.
Folding backwards
›
Pull the outer seat belt to the side panel in the direction of arrow
» Fig. 56.
›
Raise the seat backrest against the direction of arrow
handle audibly locks. Check this by pulling on the seat backrest.
A
›
Make sure that the red pin
In the undivided seat back, pull the two outer belts to the side panel. After
folding back the seat back, the release handles
place on both sides of the seat back and the red mark
on either side of the seat back.
WARNING
64
The seat backs in occupied rear seats must be properly engaged.
■
65
When transporting objects in the luggage compartment that has been en-
■
larged by folding the backrest forward, ensure the safety of the passengers
transported on the other rear seats.
The seat backrests must be securely locked in position so that no objects
■
in the luggage compartment can slide into the passenger compartment on
sudden braking – risk of injury.
CAUTION
When moving the seat backrest, the seat belts should not be trapped - there is
a risk of damage to the seat belts.
of the seat belt into the opening in
C
» Fig. 56.
in the direction of arrow and fold down the seat
1
.
2
into the two outer
C
on both sides of the seat back si-
A
until the release
2
is hidden.
B
should audibly click into
A
should not be visible
B
3