Panasonic PT-RZ31K Operating Instructions Manual page 181

[Detail control] page
Click [Projector control] → [Detail control].
1 Control of the projector
The projector is controlled by clicking the buttons in the same
way as the buttons on the remote control. After control, the on-
screen display of the projector at the right of the control page is
updated.
2 [SUB MEMORY]
Switches the sub memory.
3 [SYSTEM DAYLIGHT VIEW]
Switches to system daylight view settings.
4 [FREEZE]
Temporarily pauses the image.
5 [P IN P]
Switches the P IN P setting.
6 [LEFT/RIGHT SWAP]
Switches the flip horizontal settings.
[LENS] page
Click [Projector control] → [Detail control] → [LENS].
1 [HOME POSITION]
Moves the lens position to the home position or the
ET-D75LE95 lens standard position.
2 [SHIFT]
Press asqw to adjust the shift.
The adjustment can be performed faster by holding down the
button for approximately three seconds or longer.
3 [FOCUS]
Press qw to adjust the focus.
The adjustment can be performed faster by holding down the
button for approximately six seconds or longer.
Chapter 5 Operations — Web control function
1
2
3
4
5
6
1
2
3
4
5
6
7
7
8
9
10
11
7 [WAVEFORM MONITOR]
Displays the waveform of the input signal.
8 [PROJECTION METHOD]
Switches the setting of the projection method.
9 [LENS]
Displays the [LENS] page.
10 [TEST PATTERN]
Displays the test pattern.
Click the test pattern to display in the projected image from the
patters displayed on the right side of the control page.
The display of the test pattern disappears if [Exit] is clicked.
11 [GET OSD]
Updates the on-screen display of the projector at the right of the
control page.
4 [ZOOM]
Press qw to adjust the zoom.
5 [LENS MEMORY SAVE]
Saves the current lens position (shift, focus, and zoom). Click
the number of the lens memory to save.
6 [LENS MEMORY LOAD]
Loads the lens position (shift, focus, and zoom). Click the
number of the lens memory to load.
7 [Back]
Returns to the [Detail control] page.
ENGLISH - 181